RX (500KHz – 999MHz)
0.5 - 1.8 MHz BC Band & AMRadio
1.8 - 30 MHz Shortwave Band
30 - 78 MHz 6m Amateur
76 - 108 MHz FM Radio
108 - 137 MHz Air Band
137 - 174 MHz 2m Amateur (144 MHz)
174 - 222 MHz VHF-TV
222 - 225 MHz 1.25m Amateur(222 MHz)
225 - 420 MHz General Band 1
420 - 470 MHz 70cm Amateur (430MHz)
470 - 800 MHz UHF-TV
800 - 999 MHz General Band 2Cellular Blocked

Repeater Shift:
(144 MHz) ±600 kHz
(220 MHz) ±1.6 MHz
(430 MHz) ±1.6/5.0/7.6 MHz




TX (6m/2m/1.25m/70cm)
50 - 54 MHz
144 - 148 MHz
148 - 174 MHz MARS/CAP Mod only
222 - 225 MHz USA version only(1.5W)
430 - 440 MHz
440 - 470 MHz MARS/CAP Mod only
FRS/GMRS freq. range


MARS/CAP Mod (EnableOut-of-Band TX):
(these tidbits are from Mole****’s post)


1. Take out the battery.

2. Remove the very strong adhesive with an
X-Acto knife or very small screwdriver that you can slip under it. It’ll looklike this afterward:

3. Locate the only resistor visible on the board, just to the left of the Bluetoothplug and carefully remove it:


4. Clean off ALL the residual adhesive and put on a new (supplied) adhesivecover. This is important to preserve the waterproof seal!


Note: The radio isnow reset with no settings.